![]() ![]() For a small piece like this you may want to copper plate the piece yourself using a small brush plating kit. Copper will adhere without any problems to that type of Solder as long as the plated piece is properly degreased of course. You likely need some kind of fluoride based activation step. Oatey 95/5 Lead Free Plumbing Wire Solder is a tin-antimony wire solder designed for use in plumbing applications where frequent and extreme temperature. Is there a difference in preparation or bath chemistry that would give optimal results?Ī. I would like to send it away to a local plater but they could not give me a definitive answer if the copper would stick to the solder or not. If it does adhere, will it hold up as well enough to buff the part to an even sheen (assuming the solder doesn't melt underneath)? My question is if copper will readily adhere to the soldered areas. We would like to make those areas disappear with copper plating. There are some areas of the still that have been repaired with 95/5 solder (95% tin, 5% antimony). We have a small copper still (tabletop sized) that we are looking to restore for display purposes and occasional use. I work in the craft brewing and distillation industry. Earl WoolseyĬopper Plating Over 95/5 Tin/Antimony Solder March 10, 2017 you could use a 1/2" elbow or a 3/4" bullhead tee if you prefer, just don't dissolve the whole thing. I make my own by tossing a copper elbow (3/4") into a batch of zinc phosphate metal prep or a 10% phosphoric acid solution. You could try copper phosphate or copper dissolved in zinc phosphate. KEEP OUT OF REACH OF CHILDREN.Your purchases make possible 2000Ī. Avoid contact with eyes or internal tissue. Brush product on, heat adjacent surface and wipe when solder flows.Ĭontains zinc chloride. Black Swan 95/5 Solder-n-Flux can be used for tinning copper, brass and tin. ![]() Using wire or bar solder on all joints is helpful.
0 Comments
Leave a Reply. |